[Date Prev][Date Next]
[Chronological]
[Thread]
[Top]
(erielack) A study of two ex-D&H SD45s
- Subject: (erielack) A study of two ex-D&H SD45s
- From: "Paul Brezicki" <doctorpb_@_bellsouth.net>
- Date: Tue, 8 Aug 2006 06:45:37 -0400
Wow, good eyes, Paul, I didn't notice any of that. I recall much discussion about a year ago concerning SD45 fan housings, horn placement and clearances. I tend to favor LDY's explanation, that EL was concerned about clearances in NYNH&H territory that would host EL runthrough power. However the same low-profile treatment was applied to the Dash-2's in 1972, when this would have been much less a consideration. Someone mentioned that the M&E may have been the problem if used for detour moves. I see that the boomers did have their horns repositioned but as far as I can tell the fan housings weren't modified. Obviously there was no geographic restriction on the high-and-wide ex-Erie. I'm not completely certain about the ex-DL&W prior to the 1975 clearance project. The only boomer photo I have seen in this territory is post-modification, so if someone has a photo of 801-803 in their original state on the ex-Lacka that would answer that question. This is one of the little ironies of EL, the road of H&W clearances specifying low-profile diesels.
Paul B
* High-profile details on both units (tall fan housings, and horns centered right above the headlight) - did this limit these three units in their service area?
The Erie Lackawanna Mailing List
Sponsored by the ELH&TS
http://www.elhts.org
------------------------------